building specficiations \\ UIGOFt 2020 Residential Code of New York
��� COUf` State
man First version:Nov 2019
SECTION R507 EXTERIOR DECKS
TABLE R507.9.1.3(1)
DECK LEDGER CONNECTION TO BAND JOISTa•6(Deck live load = 40 psf, deck dead load = 10 psf, snow load
S 40 psf)
GIST SPAN
CONNECTION DETAILS 6' and 6'1"to 8'1"to 101"to 12'1"to 14'1-to 16'1-to
less is 10' 12' 14' 16' 18'
On-center spacing of fasteners
ma inch diameter lag screw with llz-inch 30 23 18 15 13 11 10
maximum sheathing•d
1/2-inch diameter bolt with 1/2-inch
maximum 36 36 34 29 24 21 19
sheathingd
1/2-inch diameter bolt with 1-inch
maximum 36 36 29 24 21 18 16
sheathings
CONNECTION DETAILSJOIST SPAN6'and less6'1"to B'8'l-to 10'10'1-to 12'12'1-to 14'14'1-to 16'16'1"to
18'On-center spacing of fasteners 1/2-inch diameter lag screw withl/2-inch
maximum sheathing,d
302318151311101/2-inch diameter bolt with 1/2-inch maximum
sheathings
363634292421191/2-inch diameter bolt with 1-inch maximum
sheathinge
36362924211816
For SI: 1 inch = 25.4 mm, 1 foot = 304.8 mm, 1 pound per square foot = 0.0479 kPa.
a. Ledgers shall be flashed in accordance with Section R703.4 to prevent water from
contacting the house band joist.
b. Snow load shall not be assumed to act concurrently with live load.
c. The tip of the lag screw shall fully extend beyond the inside face of the band joist.
d. Sheathing shall be wood structural panel or solid sawn lumber.
e. Sheathing shall be permitted to be wood structural panel, gypsum board,
fiberboard, lumber or foam sheathing. Up to 1/2-inch thickness of stacked washers
shall be permitted to substitute for up to 1/2 inch of allowable sheathing thickness
where combined with wood structural panel or lumber sheathing.
Copyright ® ICCAII Rights Reserved.
Accessed by David Hatin on 06/14/2021 pursuant to License Agreement with ICC.No further reproduction or distribution
authorized.Any Unauthorized reproduction or distribution is a violation of the federal copyright,and subject to civil and
criminal penalties thereunder.
�i DIGITAL 2020 Residential Code of New York
■ CODES State
First Version:Nov 2019
SECTION R507 EXTERIOR DECKS
i STAGGER FASTENERS
N3 IN2ROW5
C C ® 53'MIN.FOR 2 X B' 'DISTANCE SNALL BE PERMITTED TO
g BS MIN.FOR 1 X 10 BE REDUCED T04 S IF LAG SCREWS
0 0 T.Y MIN.FOR 2 X 12 ARE USED OR BOLT SPACING IS
REDUCED TO TNAT OF LAG SCREWS
TOATTACN 2 X II LEDGERS TD 2 X B
i MIN BAND JOISTS.
LEDGER LAG SCREW OR BOLT YY Mw,
For 51:1 inch =25.4 Trim.
FIGURE R507.9.1.3(1)
PLACEMENT OF LAG SCREWS AND BOLTS IN LEDGERS
Copyright ® ICC All Rights Reserved.
Accessed by David Hatin on 06/14/2021 pursuant to License Agreement with ICC.No further reproduction or distribution
authorized.Any Unauthorized reproduction or distribution is a violation of the federal copyright and subject to civil and
criminal penalties thereunder.
\\ 1::L 2020 Residential Code of New York
AIRW J'f State
low First Version:Nov 2019
SECTION R507 EXTERIOR DECKS
R507.2.4 Flashing.
Flashing shall be corrosion-resistant metal of nominal thickness not less than 0.019 inch (0.48 mm) oapproved
nonmetallic material that is compatible with the substrate of the structure and the decking materials.
Copyright ® ICC All Rights Reserved.
Accessed by David Hatin on 06/752021 pursuant to License Agreement with ICC.No further reproduction or distribution
authorized.Any Unauthorized reproduction or distribution is a violation of the federal copyright and subject to civil and
criminal penalties thereunder.
Paul Ritz
10209 Brooks Rd
r West=ville,NY 13496
315-369-9701
FIELD REPORT
CUSTOMER- JOB STIE:
S eve W;nne>' 23 Kimbdrky lane
PROJECT: QuE [1� hufV N.Y,
Dec K
5
Hur a. a.
3.
m
Sump for iechna Metal port r.tW veatiral comprenlon
bed anry.Not fespoatlhk for the con,t c of the iechno
Metal pasts to the sttmmm
Head Used 160 LOAD CAPACMES
p POST DEPTH SINK PSI CAPACTY
1 t 1000 21160
2 0 00o1 2760
3 PZ 5 O SO 22 �0
4 P2 51 O 1050 3290
5 s O 1000 2760
6
7
8
9
10
11
12
13
14
15
lnsw;m Sigrmwm:_ lJ. i O