Site Plan Submission2
Site Plan Review application – Revised October 2016
Town of Queensbury Planning Office-742 Bay Road, Queensbury, NY 12804
General Information
Tax Parcel ID Number: ____________________
Zoning District: ____________________
Lot size: _____________________
Detailed Description of Project [includes current & proposed use]:
__________________________________________________________________________________________
__________________________________________________________________________________________
__________________________________________________________________________________________
Location of project:
________________________________________________________________________________
Applicant Name: Address:
Home Phone Cell:
Work Phone Fax
E-Mail:
Agent’s Name: Address:
Home Phone Cell:
Work Phone Fax
E-mail
Owner’s Name Address
Home Phone Cell
Work Phone Fax
E-mail
3
Site Plan Review application – Revised October 2016
Town of Queensbury Planning Office-742 Bay Road, Queensbury, NY 12804
Site Development Data
Area / Type Existing sq. ft. Proposed
Addition sq. ft.
Total sq. ft.
A. Building footprint
B. Detached Garage
C. Accessory Structure(s)
D. Paved, gravel or other hard surfaced area
E. Porches / Decks
F. Other
G. Total Non-Permeable [Add A-F]
H. Parcel Area [43,560 sq. ft. / acre]
I. Percentage of Impermeable Area of Site [I=G/H]
Setback Requirements
Area
Required Existing Proposed
Front [1]
Front [2]
Shoreline
Side Yard [1]
Side Yard [2]
Rear Yard [1]
Rear Yard [2]
Travel Corridor
Height [max]
Permeability
No. of parking spaces
4
Site Plan Review application – Revised October 2016
Town of Queensbury Planning Office-742 Bay Road, Queensbury, NY 12804
Additional Project Information
1. Will the proposal require a Septic Variance from the Town Board of Health? _______________
2. If the parcel has previous approvals, list application number(s): _________________________
3. Does this project require coverage under the New York State Pollutant Discharge Elimination System
(SPDES) Permit Program ? _______________
4. Estimated project duration: Start Date __________ End Date __________
5. Estimated total cost of project: _______________
6. Total area of land disturbance for project: _______________
Floor Area Ratio Worksheet
FLOOR AREA RATIO (FAR) -- The relationship of building size to lot size, derived by dividing the total
building floor area by the lot size in square feet, yielding a percentage.
Zoning District
Symbol Floor Area Ratio [FAR]
Waterfront Residential WR 0.22
Commercial Moderate/ Intensive
CM/ CI 0.3
A. The combined area of all square footage, as measure from exterior walls of all structures on the property,
including all floors of the structures, garages, basements and attics with more than five (5) feet of ceiling
height and covered porches. Building square footage does not include: Open deck, docks and that portion of
covered docks extending over water and one storage shed of one hundred twenty (120) square feet or less.
Any additional sheds will be included. (See “FLOOR AREA RATIO”).
B. Commercial or industrial: the total area in square feet as measured from the exterior of the outside walls of a
building or structure, and when applicable, the sum total of all floor areas of the principal and accessory
buildings or structures on the project site.
A. Parcel Area ___________________________ sq. ft.
B. Existing Floor Area ___________________________ sq. ft. [see above definition]
C. Proposed Additional Floor Area ___________________________ sq. ft.
D. Proposed Total Floor Area ___________________________ sq. ft.
E. Total Allowable Floor Area ___________________________ (Area x _____) [see above table]
*If D is larger than E. a variance or revisions to your plan may be needed. Consult with Staff.
6
Site Plan Review application – Revised October 2016
Town of Queensbury Planning Office-742 Bay Road, Queensbury, NY 12804
§ 179-9-050 Checklist-Application for Site Plan Review.
Application materials and site plan shall include sufficient information for the Board to review and provide a
decision. The applicant is to provide a site plan drawing and all attachments that address items A-V. The
applicant may request a waiver from A-V and is to provide reasons for waiver(s) requested. Please label
information to be submitted.
REQUIREMENTS Sheet #
A. A vicinity map drawn at the scale that shows the relationship of the proposal to existing community facilities which affect
or serve it, such as roads, shopping areas, schools, etc. The map shall also show all properties, identify owners,
subdivisions, streets and easements within 500 feet of the property. Such a sketch may be superimposed on a United States
Geological Survey map of the area.
B. The site plan shall be drawn at a scale of forty feet to the inch (1” = 40 feet) or such other scale as the Planning Board may
deem appropriate, on standard 24” x 36” sheets, with continuation on 8 l/2 “x 11” sheets as necessary for written
information. The information listed below shall be shown on the site plan and continuation sheets.
C. Name of the project, boundaries, date, north arrow, and scale of the plan.
D. Name and address of the owner of record, developer, and seal of the engineer, architect or landscape architect. If the
applicant is not the record owner, a letter of authorization shall be required from the owner.
E. The location and use of all existing and proposed structures within the property, including all dimensions of height and
floor area, all exterior entrances, and all anticipated future additions and alterations.
F. The location of all present and proposed public and private ways, off-street parking areas, driveways, outdoor storage areas,
sidewalks, ramps, curbs, paths, landscaping, walls and fences. Location, type and screening details for all waste disposal
containers shall also be shown.
G. The location, height, intensity and bulb type (sodium, incandescent, etc.) of all external lighting fixtures. The direction of
illumination and methods to eliminate glare onto adjoining properties must also be shown in compliance with § 179-6-020.
H. The location, height, size, materials and design of all proposed signs.
I. The location of all present and proposed utility systems including:
1. Sewage or septic system;
2. Water supply system;
3. Telephone, cable and electrical systems; and
4. Storm drainage system including existing and proposed drain lines, culverts, catch basins, headwalls, endwalls,
hydrants, manholes and drainage swales.
J. Plans to prevent the pollution of surface or groundwater, erosion of soil both during and after construction, excessive runoff
and flooding of other properties, as applicable. A Stormwater Pollution Prevention Plan (SWPPP) for all land development
activities (excluding agricultural activities) on the site that results in land disturbance of one acre or more. A SWPPP shall
comply with the requirements of the DEC SPDES MS-4 General Permit and Chapter 147 of the Town of Queensbury
Code. It shall be at the discretion of the Planning Board as to whether a SWPPP or an erosion and control plan shall be
required for a site plan review project land disturbance of less than one acre.
K. Existing and proposed topography at two-foot contour intervals, or such other contour interval as the Planning Board shall
allow. All elevations shall refer to the nearest United States Coastal and Geodetic Bench Mark. If any portion of the parcel
is within the 100-year floodplain, the area will be shown and base flood elevations given. Areas shall be indicated within
the proposed site and within 50 feet of the proposed site where soil removal or filling is required, showing the approximate
volume in cubic yards.
L. A landscape plan showing all existing natural land features than may influence the design of the proposed use such as rock
outcrops, stands of trees, single trees eight or more inches in diameter, forest cover and water sources and all proposed
changes to these features, including sizes and types of plants. Water sources include ponds, lakes, wetlands and
watercourses, aquifers, floodplains and drainage retention areas.
M. Land Use District boundaries within 500 feet of the site’s perimeter shall be drawn and identified on the site plan, as well
as any Overlay Districts that apply to the property.
7
Site Plan Review application – Revised October 2016
Town of Queensbury Planning Office-742 Bay Road, Queensbury, NY 12804
REQUIREMENTS (CONTINUED) Sheet #
N. Traffic flow patterns within the site, entrances and exits, loading and unloading areas, as well as curb cuts on the site and
within 100 feet of the site. The Planning Board may, at its discretion, require a detailed traffic study for large developments or
for those in heavy traffic areas, which shall include:
1. The projected number of motor vehicle trips to enter or leave the site, estimated for weekly and
annual peak hour traffic levels;
2. The projected traffic flow pattern including vehicular movements at all major intersections likely
to be affected by the proposed use of the site;
3. The impact of this traffic on levels of service on abutting public streets and at affected
intersections. Existing and proposed weekly and annual peak hour traffic levels and road capacity
levels shall also be given.
O. For new construction or alterations to any structure, a table containing the following information shall be included:
1. Estimated area of structure to be used for particular purposes such as retain operation, office,
Storage, etc.;
2. Estimated maximum number of employees;
3. Maximum seating capacity, where applicable; and
4. Number of parking spaces existing and required for the intended use.
P. 1. Floor Plans.
2. Elevations at a scale of one-quarter inch equals one foot (1/4” = 1 foot) for all exterior facades of the proposed structure(s)
and/or alterations to or expansions of existing facades, showing design features and indicating the type and color of materials
to be used.
Q. Soil logs, water supply well and percolation test results, and storm water runoff calculations as needed to determine and
mitigate project impacts.
R. Plans for disposal of construction and demolition waste, either on-site or at an approved disposal facility.
S. Plans for snow removal, including location(s) of on-site snow storage.
T. An Environmental Assessment Form (“EAF”) as required by the SEQRA regulations, with Part 1 completed by the Applicant
shall be submitted as part of the application. If the proposed project requires a special use permit and an EAF has been
submitted in conjunction with a special use permit application, a duplicate EAF is not required for the site plan application.
U. If an application is for a parcel or parcels on which more than one use is proposed, the applicant may submit a single
application for all such uses, provided the proposed uses are accurately delineated on a site plan drawn pursuant to the
requirements set forth above. The Planning Board may grant the application with respect to some proposed uses and not
others. For purposes of reviewing an application (and for SEQRA compliance) all proposed uses on a single parcel or on
contiguous parcels shall be considered together.
V. A brief narrative statement on how the project proposed for review furthers or is consistent with the vision, goals and policies
in the Town’s Comprehensive Plan.
Town of Queensbury Site Plan Pre-Submission Conference Form / Section 179-9-040
1. Applicant Name: __________________________________________________
2. Tax Map ID ________________ Location: _______________________
3. Zoning Classification __________
4. Reason for Review: __________________________________________________________
5. Zoning Section #: ________________________
6. Pre-Submission Meeting Notes: Provided Outstanding; Please provide by
Deed ____ _____________
General Information complete ____ _____________
Site Development Data Complete ____ _____________
Setback Requirements Complete ____ _____________
Additional Project Information Complete ____ _____________
FAR addressed ____ _____________
Requirements for Site Plan-Standards ____ _____________
Checklist items addressed ____ _____________
Environmental Form completed ____ _____________
Signature Page completed ____ _____________
Staff Representative: ________________________________
Applicant / Agent: ________________________________ Date: ___________
Harvey Roadcap
309.11-2-31 7 Luzerne Road
MS/ 0.41ac
Upgrade existing day care facility with new surfaced playground area and fencing
179-3-040
X
X
NA
X
X
NA
X
X
Front required 20 ft, Rear yard required 10 ft, 5%permeable
SP46-2002, SP51-2006
Laura Moore via email 06/20/2022
Applicant proposes to upgrade the exterior play area of the existing 4,200 sq ft day care facility. The
improved playground area will include 2,000 sq ft of new surface material for playground equipment play
area. The fencing to be installed includes 137 ft of Six foot privacy fence around the playground. There is
an interior fence of 22 ft ( height and type?), also is a exterior access gate area to include a 54 inch tall
aluminum fencing. Site Plan review for fencing and exterior surfacing area for playground.
reviewed items: site plan application, floor plan, site drawing, aerial,fence detail, statement
Items to be updated or provided
1) update setback information for required column only - Required front (1) and (2) =20 ft, Required Rear
(1) and (2)=10 ft
2) permeable is 5% of lot size: in required column "5% of lot size" Existing column and Proposed column
remain the same.
3) page 4 - previous projects please add SP 46-2002 and SP 51-2006
4) clarification of the fence type dividing the two play areas.
8
111
1'
�
t
<�
s